ECM Deburring
This demonstration is a 3-D animation of our ECM process. You can see how effectively ECM uses an electrolytic solution to deburr a small hole.
Requirements - Flash Player |
|
AFM 2 Way Demo
Here you will notice the abrasive media is flowed into the internal features of the workpiece. This is where most restriction is and the unwanted materials are removed
Requirements - Flash Player |
|
TEM Process
The deburring action of the TEM process is not possible to capture on video. This 3-D animation shows you exactly what takes place inside the firing chamber of a TEM machine.
Requirements - Flash Player |
|
AFM - One Way Flow
This is another example of the AFM One Way Flow process. Here you will see the ability to conform to, and hone the internal passageways of any configuration.
Requirements - Flash Player |
|
TEM Deburring - Fly Through
This 3-D animation shows the internal passageways of a typical TEM application. A virtual fly-through shows burrs inside the part. The gas in the firing chamber is ignited and the burrs are gone.
Requirements - Flash Player |
|
AFM - One Way Flow
This 3-D animation shows how the process flows the media in one direction (One Way Flow). The media is then re-loaded in the hopper and flowed again until the desired finish is achieved.
Requirements - Flash Player |
|
TEM Deburring
This piece shows a typical burr at an intersection. The firing chamber is filled with gas, ignited and you can see the burr being vaporized.
Requirements - Flash Player |
|
